ANSI Arborist Crane Tie-In Point


Securely anchor your climbing line above the mechanical termination of the crane ball with double redundancy. Ultimate safety is provided by twin independent Teufelberger KM III lines, terminated to two ISC Steel Anchor Rings. Both ropes are covered with chafe sleeve for extra protection.

**Not for use on multi-part crane setups with running cables.**


  • Meets ANSI Z133 requirements for a crane anchor.
  • Simply choke the two smaller rings through the large forged ring and tighten securely around the crane cable, above the mechanical termination.
  • The two eyes on the large ring are stitched several inches from the ring, in order to allow the sling to choke tightly on a crane cable.


MBS: 5,400 lbs.

Total Length: 41"

Choked Length: about 33" below choke point on 1" line

Write Your Own Review
You're reviewing:ANSI Arborist Crane Tie-In Point
Your Rating

Follow Us on Facebook

Follow Us on Instagram

TreeBuzz Forum

Copyright © 2020 Arbsession. All rights reserved.