Arbsession Friction Saver for Cranes
The Arbsession Friction Saver for Cranes is a great tool to safely tie into a crane load line above the ball. With the use of two ISC steel rings friction is reduced for your climb line!
Details
To install locate the load line above the crimped termination and crane ball. Pass the two smaller rings through the larger steel ring. Cinch the friction saver tight to the load line.
Meets a minimum breaking strength of 5,400 lbs.
Total length is just over 40 inches.
NOT FOR USE on crane setups with running cables.
More Information
Ask An Expert
Customer Questions
It could be girthed to a shackle as well but you would need to lock the pin on the shackle in a way that it can't unthread itself. This friction saver for cranes was built to girth around the cable above the ball on the cable itself.
Safe
Very well constructed had it for a couple of months now
Keeps your rope safe
Great quality that gives you peace of mind when hanging way tf up there
Crane lifeline
Important to use something sturdy for a crane lifeline, and this Arbsession Friction Saver for Cranes definitely is.
Absolute necessity for crane work
You're hanging your life on this, don't cheap out. This is ANSI approved for tying into a crane as it is technically two separate tie in points. As always, arbsession quality abounds.
necessity for crane work
I wouldn't trust my life support on a crane without something protecting it such as this has. If you are like me and hire a crane company they likely work in many different situations and there can be burrs on the ball that would make me feel unsafe using anything without a protective covering.